Water running right now? Shut off the main valve, then call Pure Cleaning and Restoration at [CLIENT PHONE]. Our team serves Salt Lake City, Davis County and the Wasatch Front. See our water damage restoration services.
Short answer: When a pipe bursts, turn off the main water valve first. Then cut power to wet areas if you can do it safely, open faucets to drain the lines, take photos, and call a plumber and a water damage restoration company. Acting in the first hour limits how far the water spreads.
Here is the full order, in plain steps.
Step 1: Shut Off the Main Water Valve
Every minute the pipe runs, more water soaks into floors, walls and ceilings. Stop it first.
- Find the main shutoff. In many Utah homes it sits in the basement, a utility room, a crawl space or near the water heater. Some are outside near the meter.
- Turn it clockwise until it stops. A lever-style ball valve turns a quarter turn.
- If the valve is stiff, do not force it. A snapped valve makes things worse. Close the shutoff nearest the broken pipe instead and call a plumber.
- Open one faucet. If the water stops, you got the right valve.
Not sure where yours is? Find it today, not during an emergency. Tell everyone in the house where it is. FEMA’s winter readiness guide also lists learning to shut off the main water valve as a basic step (FEMA Winter Ready tips).
Step 2: Turn Off Power to Wet Areas
Water and electricity do not mix.
- If water is near outlets, appliances or the breaker panel, switch off power to that area at the panel.
- Only do this if the panel is dry and you can reach it without stepping in water.
- If you can’t reach it safely, stay out and call an electrician or a restoration pro for guidance.
- Never use a wet vacuum or plug in a fan while standing in water.
Step 3: Drain the Pipes
With the main off, open faucets to let the leftover water out. This takes pressure off the system and keeps more water from leaking at the break.
- Open cold taps on every floor, starting upstairs.
- Flush toilets once or twice.
- Turn off the water heater (power or gas) so the tank does not run dry while heating.
- Open hot taps to drain the hot side.
Step 4: Move What You Can and Take Photos
- Move rugs, small furniture and electronics out of the wet area.
- Lift furniture legs onto foil or blocks so they do not stain the carpet.
- Take photos and video of the broken pipe, the water and every damaged item before you move or toss anything. Your insurer will want them.
- Keep damaged items you replace until your adjuster says you can discard them.
Step 5: Call a Plumber and a Restoration Company
You need both, and the order matters less than calling quickly.
- The plumber repairs or replaces the broken pipe.
- The restoration company removes water and dries the structure.
Many homeowners wait for the plumber first and lose a day. Call both at once. A repaired pipe does not dry your walls. If you want to understand who does what, read our guide on mitigation vs. restoration once it is live (link once live).
Why the First 24 to 48 Hours Matter
The EPA says wet materials should be dried within 24 to 48 hours to prevent mold growth (EPA, Mold Cleanup in Your Home). That window is short. Wet drywall, insulation and carpet pad can hold water long after the surface feels dry.
A restoration team uses:
- Truck-mounted or portable extractors to pull standing water
- Air movers and dehumidifiers to dry the air and materials
- Moisture meters and thermal cameras to find hidden wet spots behind walls and under floors
If mold has already started, see our mold removal service.
What Happens When You Call Us
Knowing what comes next makes the call easier.
- You describe the loss. Tell us where the pipe broke, how long it ran and which rooms are wet.
- A crew arrives. We look at the damage and check the structure for safety.
- We find the water. Moisture meters and thermal cameras show wet areas behind walls, under floors and above ceilings.
- We remove the water and set up drying. Extractors pull standing water. Air movers and dehumidifiers dry the rest.
- We track the progress. Daily moisture readings show when materials are dry, and the records support your insurance claim.
- We clean and restore. Affected areas get cleaned, and we help you plan any repairs.
Signs of Hidden Water After a Burst Pipe
Even after the visible water is gone, watch for these signs over the next few days:
- Musty smell in a room, closet or basement
- Paint or wallpaper that bubbles, peels or stains
- Warped floors or baseboards that lift from the wall
- Ceiling spots that spread or sag
- Higher humidity or a window that stays foggy
If you see any of these, call a pro. A moisture check is quick and can save you from a bigger repair later.
What Not to Do
- Do not ignore “just a small leak.” Hidden water can spread inside walls.
- Do not use a torch to thaw a frozen section. The CDC says to thaw frozen pipes slowly with warm air from an electric hair dryer (CDC winter storm safety).
- Do not drink the tap water if the pipes have broken open. The CDC advises using bottled water or getting water from a neighbor’s home in that case.
- Do not turn the water back on until the pipe is repaired.
- Do not wait on the claim to start drying. Mitigation is part of your duty after a loss, and photos protect you.
Is a Burst Pipe Covered by Insurance?
Often, yes, when the break is sudden and accidental. Policies differ, and gradual leaks or neglect are often treated differently. Read your policy or ask your agent. For the full process, see our guide on how property damage insurance claims work once it is live (link once live).
Tips that help your claim:
- Call your insurer soon after the loss.
- Share your photos and video.
- Keep invoices from the plumber and the restoration company.
- Ask the restoration team for a moisture log and drying report.
How Much Does Burst Pipe Cleanup Cost?
It depends on how long the water ran, how many rooms it reached, and whether materials must be torn out. A quick shutoff and fast drying cost far less than a slow response with mold. Our water damage restoration cost guide explains what drives the price in Utah.
Why Utah Property Owners Call Pure Cleaning and Restoration
- Local and veteran-owned. We have served Utah since 2011 from Kaysville.
- One team for the whole job. Water removal, drying, cleaning and mold work under one roof.
- We help with insurance paperwork. Documentation, moisture logs and photos.
- Wide coverage. See all our service areas, from Salt Lake City to Davis County.
Need help now? Call [CLIENT PHONE] or visit our water damage restoration page.
Stop the Next Burst Before It Happens
Most Utah burst pipes happen when temperatures drop and water freezes inside the line. Our frozen pipes guide covers insulation, thermostat settings and faucet drips (link once live). For year-round habits, read how to prevent costly water damage. FEMA suggests keeping the furnace at 55°F or higher to help the home stay above freezing.
Frequently Asked Questions
What is the first thing to do when a pipe bursts?
Turn off the main water valve. Then switch off power to wet areas if it is safe, and open faucets to drain the lines.
Should I call a plumber or a restoration company first?
Call both right away. The plumber fixes the pipe. The restoration company removes water and dries the structure so mold does not start.
How fast does water damage become mold?
The EPA says to dry wet materials within 24 to 48 hours to prevent mold growth. Fast action matters.
Can I clean up a burst pipe myself?
You can mop small amounts of clean water and move belongings. Water in walls, insulation, flooring or ceilings needs professional drying equipment.
Is the water from a burst pipe clean?
Water from a supply line starts clean, but it can pick up dirt and bacteria from floors and building materials. If it sits, it becomes a bigger risk. Sewage or drain water is different and needs special care.
Does homeowners insurance cover a burst pipe?
Often yes, when the break is sudden and accidental. Check your policy and call your insurer promptly.
What if I can’t find my main shutoff valve?
Shut off the valve nearest the broken pipe, or call a plumber. Some homes also have a shutoff at the meter, which may need a special tool.
Does Pure Cleaning and Restoration serve Salt Lake City?
Yes. We serve Salt Lake City, Davis County and the surrounding Utah areas. Call [CLIENT PHONE] for fast help.
Sources
- FEMA, Winter Ready: Winterizing Your Home
- CDC, Safety Guidelines: During & After a Winter Storm
- American Red Cross, Preventing & Thawing Frozen Pipes
- EPA, Mold Cleanup in Your Home